Setting Trace Views - Siemens SINUMERIK 828D Commissioning Manual

10.4.4.2

Setting trace views

In order to permit a precise evaluation of the recorded signals, you have the option to edit the
view as well as the display of the characteristic graphs:
● Selection/legend
– Show legend: In addition to the graphic display, the data of the variable is displayed as
– Make a selection: You define which variables are displayed in the graphic window.
● Scale
– Specifying scaling factors for minimum and maximum X and Y value
● Zoom
– Increasing or decreasing the section
● Cursors: The cursor display provides functions that allow one, two or both curves to be
precisely measured.
– Cursor A
– Cursor B
– Both cursors
– Snap to curve: The cursor precisely moves along the curve
– Point mode: Cursor jumps directly to various values.
– High point mode: The cursor jumps from one peak value to the next.
– Low point mode: Cursor jumps to the lowest values.
Requirement
The "Trace" graphic window is open and the trace has been recorded.
Editing curves
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
comment, numbered and in color.
You jump from one variable to the next using the <TAB> key.
You jump back using the <Ctrl> and <TAB> keys.
With the cursor keys, you set marks, move to individual values and can
define a zoom range.
Service and diagnostics
10.4 Trace
355