Siemens SINUMERIK 828D Commissioning Manual page 547

Note
Measuring feedrate for workpiece measuring
All measuring cycles use the value saved in SD54611 as the measuring feedrate value
following calibration of the workpiece probe. A different measuring feedrate can be assigned
for each calibration field [n].
When calibrating the probe, either the measuring feedrate from SD55630
$SCS_MEA_FEED_MEASURE is used, or the measuring feedrate can be overwritten in the
input screen when calibrating. To do this, SD54760 $SNS_MEA_FUNCTION_MASK_PIECE
bit 4 must be set to 1.
MD52207 $MCS_AXIS_USAGE_ATTRIB[n]
Bit 6
MD51751 $MNS_J_MEA_M_DIST_MANUELL
= 10
MD51757 $MNS_J_MEA_COLL_MONIT_FEED
= 1000
MD51758 $MNS_J_MEA_COLL_MONIT_POS_FEED
= 1000
MD51770 $MNS_J_MEA_CAL_RING_DIAM[n]
= -1
MD51772 $MNS_J_MEA_CAL_HEIGHT_FEEDAX[n]
= -99999
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Request rotary axis as correction target for measuring.
= 0 Default value
=1 Rotary axis is displayed as correction target in the "Measuring in JOG" window.
Default value
Default value
Default value
Default value
Default value
7.9 Measuring cycles and measurement functions
Attributes of the axes
[n] channel axis number
Measuring path in mm, before and after the
measuring point.
Position feedrate in mm/min, in the working
plane for active collision monitoring.
Position feedrate in mm/min, in the infeed
axis for active collision monitoring.
Pre-assignment of the calibration diameter
in mm specifically for the calibration data
sets.
Pre-assignment of the calibration height
in mm, in the infeed axis, specific for the
calibration data sets.
Configuring cycles
179