Siemens SINUMERIK 828D Commissioning Manual page 147

Spindle machine data
To operate the spindle in the previous example in JOG mode after commissioning the drive,
enter the new values for the following machine data:
Spindle machine data
MD32000
MD32010
MD32020
MD35100
MD35110[0]
MD35110[1]
MD35130[0]
MD35130[1]
MD36200[0]
MD36200[1]
Maximum speed drive parameter
After a DDS switchover, e.g. DDS0 → DDS1, the spindle can only be traversed with the speed
from p1082[0]. If a value less than that in p1082[1 ... n] is entered in p1082[0], the spindle
speed is limited to the value in p1082[0].
Note
The maximum speed must be entered in parameter p1082[0]:
● If the parameter is assigned a greater value than in the other parameters, the spindle can
be traversed with the maximum speed.
● If parameter p1082[0] is subsequently changed to a lower value and then a "Reset (po)"
performed, then the spindle only traverses with the lower value from p1082[0]. All other
values are ignored.
Diagnostics displays
Further information on the status of axes and spindle is available in the "Diagnostics" operating
area with the menu forward key:
● The "Axis diagnostics" softkey opens the "Service Overview" dialog.
● The "Service axis" softkey opens the "Service Axis/Spindle" dialog.
CNC commissioning
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
$MA_MAX_AX_VELO
$MA_JOG_VELO_RAPID
$MA_JOG_VELO
$MA_SPIND_VELO_LIMIT
$MA_GEAR_STEP_MAX_VELO[0]
$MA_GEAR_STEP_MAX_VELO[1]
$MA_GEAR_STEP_MAX_VELO_LIMIT[0]
$MA_GEAR_STEP_MAX_VELO_LIMIT[1]
$MA_AX_VELO_LIMIT[0]
$MA_AX_VELO_LIMIT[1]
Commissioning the drive
5.2 Assigning axes
Default setting New value
10000 3000
10000 100
2000 50
10000 3000
500 3000
500 3000
500 3150
500 3150
11500 3300
11500 3300
133