Siemens SINUMERIK 828D Commissioning Manual page 558

Configuring cycles
7.9 Measuring cycles and measurement functions
Note
Measuring feedrate for workpiece measuring
All measuring cycles use the value saved in SD54611 $SNS_MEA_WP_FEED[n] as measuring
feedrate after the tool probe has been calibrated.
A different measuring feedrate can be assigned for each calibration field [n].
When calibrating the probe, either the measuring feedrate from SD55630
$SCS_MEA_FEED__MEASURE is used, or the measuring feedrate can be overwritten in the
input screen when calibrating. To do this, SD54760 MEA_FUNCTION_MASK_PIECE bit 4
must be set to 1.
SD55632 $SCS_MEA_FEED_RAPID_IN_PERCENT
= 50
SD55634 $SCS_MEA_FEED_PLANE_VALUE
= 1000
SD55636 $SCS_MEA_FEED_FEEDAX_VALUE
= 1000
SD55638 $SCS_MEA_FEED_FAST_MEASURE
= 900
SD55640 $SCS_MEA_FEED_CIRCLE
= 1000
190
Default value of the percentage reduction of the rapid traverse velocity for internal cycle
intermediate positioning without collision monitoring.
The setting of the channel-specific cycle setting data SD55600 SCS_MEA_COLLI‐
SION_MONITORING must be = 0.
Default value
Default value
Default value
Default value
Percentage reduction
Feedrate of the intermediate positioning
in the working plane with active collision
monitoring.
Feedrate of the intermediate positioning
in the infeed axis with active collision mon‐
itoring.
Fast measuring feedrate
Feedrate with circle programming
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate