Siemens SINUMERIK 828D Commissioning Manual page 650

Tool management
9.2 Configuring the user interface
Parameter
REASONXXX
Text
Parameter
BitMask
Local variable of the SICap service
The identifier of the local variables is called "/Hmi/ToolEdgeReplacementReason". The
variable is the string type.
The table below lists the most important arguments and their significance:
Argument
datetime
containerNo
toaNo
toolNo
edgeNo
toolIdent
toolDuplo
ncuName
reactivationReason
monitoringMode
remainingBefore
Example 1
The following example uses the texts for the tool change reason, already prepared in the
operating software. In this example, the tool change reason is stored in parameters that still
have to be configured, e.g. the OEM tool data 1, bit 1 and following.
<TOOLCHANGEREASON>
<Enabled value="true" type="bool" />
282
Designation
XXX stands for an internal number. The numbers for the tool change
reason must be clear and unique.
Text identifier of the tool change reason.
Parameter identifier of the parameter in which it is entered whether the
tool change reason was selected.
Bit mask to enter the reason for the change in the local variable of the
SlCap service. The bit mask is entered as integer value. Bit 0 → 1,
bit 1 → 2, bit 2 → 4
Meaning
Date and time of the event
Number of the management area
Number of the TO area
Tool number
Cutting edge number
Tool name
Replacement tool number
Name of the NCU
Reason for tool change
Monitoring type
Remaining unit quantity/tool lifetime before reactivation
<REASON1>
<Text value="TM_DGL_DESIRED_PIECES_ELAPSED" type="QString" />
<Parameter value="ToolUser_1_Bit1" type="QString" />
</REASON1>
<REASON2>
<Text value="TM_DGL_TOOL_BREAKAGE" type="QString" />
<Parameter value="ToolUser_1_Bit2" type="QString" />
</REASON2>
<REASON3>
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate