Siemens SINUMERIK 828D Commissioning Manual page 619

</PARAMETERCONFIGURATION>
Configuring new list parameters based on an existing list parameter.
Assign a new parameter name and enter only the changed data:
Entries
Base
Example 1
<PARAMETERCONFIGURATION>
</PARAMETERCONFIGURATION>
Example 2
Entries
Base
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
<Width value="53" type="int" />
<DisplayMode value="DoubleMode" type="QString" />
<DecimalPlaces value="2" type="int" />
</GeoRadius>
Meaning
Assign new parameter name
See example 1: Text "NewGeoRadius"
Name of the parameter on which the new parameter is based.
See example 1: "GeoRadius" parameter is used as a template.
Also enter only the changed data here. All other data is taken from the existing
parameter.
See example 1: Column width changed to 46 pixels. Number of decimal places
changed to 1.
<NewGeoRadius>
<Base value="GeoRadius" type="QString" />
<Width value="46" type="int" />
<DisplayMode value="DoubleMode" type="QString" />
<DecimalPlaces value="1" type="int" />
</NewGeoRadius>
Meaning
Assign new cutting edge parameter name
The name is "EdgeUser_1_Bit0" in the following example.
Name of the parameter on which the new parameter is based.
In the following example, the "EdgeUser_1" parameter is used as template.
Tool management
9.2 Configuring the user interface
251