Reason For The Tool Change When Reactivating - Siemens SINUMERIK 828D Commissioning Manual

</context
</TS>
9.2.23

Reason for the tool change when reactivating

Precondition
Function
When reactivating a tool, you have the option of specifying the reason for the tool change, e.g.
to use this information for statistical purposes. The "Reason for Tool Change" selection window
is opened after pressing the "Reactivate" softkey. In a checkbox, you can select the reason
for the tool change. The tool change is entered in a tool parameter to be configured or in a
local variable of the SlCap service.
Tool change reasons
You can adapt or expand the tool change reasons as required. The operating software provides
the following pre-defined texts for the configuration:
Text identifier
TM_DGL_DESIRED_PIECES_ELAPSED
TM_DGL_TOOL_BREAKAGE
TM_DGL_CUTTING_EDGE_DAMAGE
TM_DGL_PREMATURE_WEAR
TM_DGL_TYPE_REEQUIPPING
TM_DGL_TOOL_TRIAL
TM_DGL_PREVENTIVE_CHANGE
<TOOLCHANGEREASON> tag
You configure the function in the <TOOLCHANGEREASON> tag:
Parameter
Enabled
OnlyOneReasonAllowed
UseCapLocalParameter
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Software option
You require the "MC Information System TDI Statistic" option for this function
Designation
True - "Reason for tool change" selection window is displayed when
reactivating.
False - default value, selection window is not displayed.
It is only permissible to select one tool change reason.
The reason for the tool change is entered into a local variable of the
SlCap service.
9.2 Configuring the user interface
Text
Unit quantity setpoint (desired pieces) elapsed
Tool breakage
Cutting edge damage
Premature wear
Type reequipping
Tool trial
Preventive change
Tool management
281