Siemens SINUMERIK 828D Commissioning Manual page 540

Configuring cycles
7.9 Measuring cycles and measurement functions
Program code
N45 R2=$AA_MW[X]
N50 M0
N55 M30
N60 _FEHL1: MSG ("Probe does not switch!")
N65 M0
N70 M30
General function settings for measuring cycles
MD51740 $MNS_MEA_FUNCTION_MASK
Bit 0
Bit 1
Bit 2
Bit 4
Bit 15
Bit 16
Note
After changing this machine data, the probe must be re-calibrated.
MD52740 $MCS_MEA_FUNCTION_MASK
Bit 0
Bit 1
Bit 2
Bit 16
MD54740 $SNS_MEA_FUNCTION_MASK
Bit 0
Bit 1
172
Activate calibration status monitoring – workpiece measurement for measuring in automatic
Length reference for workpiece probe, milling technology
= 0 Tool length L1, referred to the center of the probe sphere
= 1 Tool length L1, referred to the sphere circumference of the probe sphere
Support of tool carriers that can be orientated for workpiece measurement with correction
in a tool
Workpiece probe is permanently attached to the machine and cannot be positioned
Workpiece measurement, traverse measuring block with path behavior G60 with exact stop
at the end of the block
Tool, turning technology, consideration of toolholders
Measuring input, workpiece probe
= 0 Workpiece probe at the CNC measuring input 1, active - default
= 1 Workpiece probe at the CNC measuring input 2, active
Workpiece measurement, functional behavior of a third geometry axis (Y axis) when turning,
based on the machining plane G18!
Calculation of the correction angle with/without active orientation transformation
Measuring input, tool probe
= 0 Tool probe at the CNC measuring input 1, active - default
= 1 Workpiece probe at the CNC measuring input 2, active
Repeat measurement, workpiece measurement after exceeding a dimensional difference
(parameter _TDIF) and or confidence range (parameter _TSA)
Repetitive measurements: workpiece measurement with alarm and cycle stop at M0
Comment
;Save measured value in workpiece coordi-
nates at R2
;Check measured value in R1/R2
Measuring cycles function screen
Measuring cycles function screen
Measuring cycles function screen
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate