Siemens SINUMERIK 828D Commissioning Manual page 513

The fine offsets act in addition to the corresponding base vectors when the Swivel function
CYCLE800 or the NC function TCARR=n is called.
$TC_CARR41[n]
Assignment of the basic vectors to the vectors of the fine offset:
I1
I2
I3
I4
The fine offsets are activated by the following setting data:
SD42974 $SC_TOCARR_FINE_CORRECTION = 1
= 0
= 1
Name of rotary axes
Figure 7-7
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
$TC_CARR1...3[n]
$TC_CARR4...6[n]
$TC_CARR15...17[n]
$TC_CARR18...20[n]
When activating a tool carrier that can be oriented, the fine offset values are not taken into
account.
When activating a tool carrier that can be orientated, the fine offset values are taken into account.
Dialog to input parameters for the rotary axis
to $TC_CARR60[n]
to $TC_CARR41...43[n]
to $TC_CARR44...46[n]
to $TC_CARR55...57[n]
to $TC_CARR58...60[n]
Fine offset TCARR on/off
Configuring cycles
7.7 Swiveling
145