Measuring Tools At The Milling Machines - Siemens SINUMERIK 828D Commissioning Manual

Configuring cycles
7.9 Measuring cycles and measurement functions
General cycle setting data
SD54780 $SNS_J_MEA_FUNCTION_MASK_PIECE
= 512
Bit 2 = 1
Bit 3 = 1
Bit 6 = 1
Bit 7 = 1
Bit 8 = 1
Bit 9 = 1
7.9.3.2

Measuring tools at the milling machines

Measuring feedrate for tool measurement in JOG and AUTOMATIC
SD55628 $SCS_MEA_TP_FEED_MEASURE
= 300
Note
Measuring feedrate for tool measuring
All measuring cycles use the value saved in SD54636 or SD54651 as the measuring feedrate
after the tool probe has been calibrated. A different measuring feedrate can be assigned for
each calibration field [n].
When calibrating the probe, either the measuring feedrate from
SD55628 SCS_MEA_TP_FEED_MEASURE is used, or the measuring feedrate can be
overwritten in the input screen when calibrating. To do this,
SD54762 $SNS_MEA_FUNCTION_MASK_TOOL bit 4 must be set to 1.
In the following setting data, index [k] stands for the number of the current data field (probe
number -1) of the probe.
SD54633 $SNS_MEA_TP_TYPE[k]
= 0
= 101
= 201
= 301
180
Default value
Activates measurements with an electronic probe.
Selects the probe calibration data, enable.
Selects ZO offset in the basis reference (SETFRAME), enable.
Selects ZO offset in the channel-specific basic frame, enable.
Selects ZO offset in the global basic frame, enable.
Selects ZO offset in adjustable frames, enable.
Default value
Cube (default value)
Disk in XY, working plane G17
Disk in ZX, working plane G18
Disk in YZ, working plane G19
Configuration of the input screens for
measuring in the "Machine" operating
area in the JOG operating mode.
Calibrate measuring feedrate for tool
probe and measure tool with station‐
ary spindle.
Probe type, cube/disk
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate