Siemens SINUMERIK 828D Commissioning Manual page 274

Tool management
9.2 Machine data for the tool management
Part program:
N10 T="Drill18"
N20 M6
Tool change subprogram L6:
N10 M206
N20 D0
N40 Y150 M79
N50 G01 D1 X10
MD20310: $MC_TOOL_MANAGEMENT_MASK
Activating the tool management functions:
MD20310: $MC_TOOL_MANAGEMENT_MASK
Bit 0
Bit 1
Bit 2
Bit 3
Bit 14
Bit 23
Bit 24
Additionally only for T version:
Bit 16
If a locked tool is at the programmed location, the location of a replacement tool (if available)
is output as job from the tool management when the "Replacement tools for tool management"
option is set.
260
; Tool change preparation
; Tool change subprogram called
; Tool change
: Compensation deselected
; Traverse machine axes
; Activate tool compensation.
; Check whether tool has been changed.
; Preprocessing stop is maintained until tool change prep-
aration is completed. The main run waits at N50 (D1) until
tool change has been executed and acknowledged.
= 1 Tool management active:
The functions of tool management are enabled for the current channel.
= 1 Monitoring functions of tool management active:
The functions for monitoring tools (tool life and workpiece count) are enabled.
= 1 OEM functions active
= 1 Adjacent location consideration active
= 1 Tool and offset selection according to the settings in:
MD20110 $MC_RESET_MODE_MASK
MD20112 $MC_START_MODE_MASK
= 1 With offset selection no synchronization with main run.
= 1 Using an asynchronous transfer with acknowledgment status 201, you can move
a tool to a location reserved for another tool with "reserved for tool from buffer".
This location reservation is then removed before the movement is executed ("Re‐
served for new tool to be loaded" (bit value="H8") remains effective).
= 1 T location number is active.
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
CNC commissioning