Siemens SINUMERIK 828D Commissioning Manual page 458

Configuring cycles
7.3 Manufacturer cycles
Program test run
To support the program test run, the following dialog is available under "Program control" →
"Approach":
Figure 7-2
In the dialog, specify which channel and which spindle should be used for the program test
run.
The check marks for the program test run (dry run) are displayed as follows in the PLC:
(check mark = processing = no dry run = 0)
● Channel 1...n: DB330x.DBX1.7
● Spindle n: DB380x.DBX1.3
Note
An example for commissioning the positioning function is also supplied in the
SINUMERIK 828D Toolbox.
All required M-commands must be grouped. Some groups are predefined for the standard M-
commands (e.g. M3, M4, M5, ...), see following machine data item:
MD22040 $MC_AUXFU_PREDEF_GROUP
90
Program test run
Group assignment of predefined auxiliary functions.
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate