Tool Management; Machine Data For Tool Management; Settings With/Without Magazine Management - Siemens SINUMERIK 828D Commissioning Manual

Tool management

9.1

Machine data for tool management

9.1.1

Settings with/without magazine management

Setting without magazine management
Make the following settings if you are commissioning the tool management without NC
magazine management:
MD18080 $MN_MM_TOOL_MANAGEMENT_MASK
= 13E
Bit 0 = 0
Bit 1 = 1
Bit 6 = 0
Note
Machine data MD18080 can only be set for the technology variants cylindrical and surface
grinding.
MD20310 $MC_TOOL_MANAGEMENT_MASK
= 420EH
Bit 0 = 0
Bit 1 = 1
MD17530 $MN_TOOL_DATA_CHANGE_COUNTER
= 1FH
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Do not provide tool management data.
Provide monitoring data.
Magazines not divided into wear groups.
Magazine management inactive.
Monitoring functions of tool management active.
Tool status change.
Tool remaining unit quantity change.
Tool data change service.
Magazine data in the change service.
ISO data in the change service.
Memory for the tool management is re‐
served step-by-step (SRAM).
Activating the tool management functions.
Marking the changed tool data for HMI.
9
221