Siemens SINUMERIK 828D Commissioning Manual page 545

MD52750 $MCS_J_MEA_FIXPOINT
[0]
[1]
MD52751 $MCS_J_MEA_MAGN_GLAS_POS
[0]
[1]
Checking and setting the general machine data
MD11450 $MN_SEARCH_RUN_MODE
Bit 1 = 1
MD11604 $MN_ASUP_START_PRIO_LEVEL
= 1 - 64
Setting channel-specific machine data
MD20050 $MC_AXCONF_GEOAX_ASIGN_TAB[ ]
[0]
[1]
[2]
MD20110 $MC_RESET_MODE_MASK
= 4045H
Bit 0 = 1
Bit 2 = 1
Bit 6 = 1
Bit 14 = 1
MD20112 $MC_START_MODE_MASK
= 400H
Bit 6 = 0
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Position in the 1st axis
Position in the 2nd axis
Position in the 1st axis
Position in the 2nd axis
Automatic ASUP start after output of action sets. Alarm 10208 is not output until the ASUP
is ended (see also MD11620 $MN_PROG_EVENT_NAME).
Priorities for ASUP_START_MASK.
For measuring in JOG mode, all of the geometry axes must be available. Preferably XYZ.
Minimum value
Basic control setting after power on and reset.
Minimum value
Definition of the basic control setting after NC start.
7.9 Measuring cycles and measurement functions
Z value for measurement with respect to
a fixed point
Zoom-in position for tool measurement
Block search parameter settings
Priorities from which ASUP_START_MASK is
effective.
Assignment, geometry axis to channel axis.
Defines the basic control settings after reset /
TP end,
Definition of the basic control setting after part
program start.
Configuring cycles
177