Manufacturer Cycle For Tool Change Cust_T And Cust_M6 - Siemens SINUMERIK 828D Commissioning Manual

Note
If $P_PROG_EVENT==5 is used in the CYCPE_MA.SPF, no REPOSA may be programmed
as this is already present in the PROG_EVENT.SPF, otherwise an error occurs for SSL with
calculation.
7.3.3

Manufacturer cycle for tool change CUST_T and CUST_M6

Function
The two cycles are used to track the T preparation (CUST_T) and the tool change (CUST_M6)
according to SERUPRO. In so doing, depending on the specific toolholder, the following is
output:
● Last programmed change
● Last programmed preparation
Sequence
The two cycles are called in the "SERUPRO-END-ASUB", which also provides the two transfer
parameters.
Parameter
_THnr
_MTHnr
The cycles themselves do not contain and "machine logic". Pure data operations are performed.
The active toolholder or the master spindle is saved.
Using the transfer parameter, the situation at the time of the T or M6 programming is
determined. This situation is established, T and/or M06 output or a branch is made into the
manufacturer cycles. After the output of T and M06 or after returning from the manufacturer
cycles, the toolholder, saved at the beginning, is reactivated.
A change cycle can then only be called without any restriction, if the corresponding queries
such as program test, block search,...exist.
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Meaning
Toolholder or master spindle number that was programmed for the change or the
preparation.
Number of the active toolholder or master spindle at the time of programming.
Configuring cycles
7.3 Manufacturer cycles
83