Note
If the field "Use time server" is cleared again, the standard "UTC" time zone will apply again.
1.4
Changing the language
The operating software is available as standard in several languages.
Selecting a language
You can define the language selection mode using the following machine data.
MD9100 $MM_CHANGE_LANGUAGE_MODE
= 1
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
7.
Press the "Set time server" softkey.
If a connection to a time server exists, the settings will be synchronized
with the system immediately. After that, a cyclic check is made as to
whether the settings are effective. The "Set Date and Time" window re‐
mains open.
8.
Confirm the entry with the "OK" softkey.
The time server settings and the current times are taken over from the
control.
The user-interface language is specified via the "Language Selection" window (default val‐
ue).
1.
Select the "Start-up" operating area.
2.
Press the "Change language" softkey.
The "Language Selection" window opens. The language most recently
set is highlighted.
3.
Switch the cursor to the required language.
4.
Press the <INPUT> key.
- OR -
Press the "OK" softkey.
The operating software switches to the language selected.
1.4 Changing the language
Language selection mode
General settings
19