Siemens SINUMERIK 828D Commissioning Manual page 448

Configuring cycles
7.2 Technology cycles for drilling
Bit 2
Bit 3
Bit 4
Bit 6
Bit 7
Tapping (CYCLE84 and CYCLE840)
If the technology screens are hidden using the channel-specific configuration machine data
MD52216 $MCS_FUNCTION_MASK_DRILL, then the settings in the following channel-
specific cycle setting data are effective:
SD55481 $SCS_DRILL_TAPPING_SET_GG12[0]
= 0
= 1
= 2
= 3
SD55482 $SCS_DRILL_TAPPING_SET_GG21[0]
= 0
= 1
= 2
= 3
80
Boring CYCLE86: When positioning the spindle, take into account swiveled table kinematics
(tool carrier)
= 0 When positioning the spindle, do not take into account the components of the swiveled table
kinematics (swiveling with CYCLE800, tool carrier).
Note:
Only the rotary axis of the machine kinematics that rotates the workpiece is taken into ac‐
count. In the initial state of the kinematics, this rotary axis must be orientated parallel to the
tool axis.
e.g. rotary axis C rotation around Z (for G17) rotary axis vector of the swivel data set V2xyz
= 0 , 0 , -1.
= 1 When positioning the spindle, take into account the components of the swiveled table kine‐
matics (swiveling with CYCLE800, tool carrier).
Tapping CYCLE84: Monitoring of the machine data MD31050 $MA_DRIVE_AX_RATIO_DE‐
NOM and MD31060 $MA_DRIVE_AX_RATIO_NUMERA of the spindle
Tapping CYCLE84, set monitoring of the machine data MD31050 $MA_DRIVE_AX_RA‐
TIO_DENOM and MD31060 $MA_DRIVE_AX_RATIO_NUMERA of the spindle
= 0 No monitoring
= 1 Monitoring
Boring CYCLE86: Adapt the spindle position to the tool orientation
Tool orientation can be realized using TOOLCARR or TRAORI before the cycle is called.
= 1 Bits 1 and 2 are no longer effective.
Boring CYCLE86: Adapt the direction of retraction travel in the plane to the active mirroring
= 0 Retraction in the plane is realized as programmed.
= 1 When mirroring is active, the direction when retracting in the plane is adapted in the cycle
to the active mirroring.
Exact stop response as before the cycle call (default value).
G601
G602
G603
Acceleration behavior as before the cycle call (default value).
SOFT
BRISK
DRIVE
Setting tapping G group 12:
Block change behavior for exact stop
Setting tapping G group 21:
Acceleration behavior
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate