Single-Channel And Two-Channel Sensors - Siemens SINUMERIK 828D Commissioning Manual

Configuring cycles
7.5 Turning
a
b
As the tool bends during plunge turning, the tool would make an excessively deep cut during
stock removal. The retraction distance of the tool between plunge-cutting and stock removal
is specified in the following channel-specific cycle setting data:
SD55596 $SCS_TURN_CONT_TURN_RETRACTION
= 0.1
7.5.7

Single-channel and two-channel sensors

General configuration
If rotating milling tools are available on a turning machine, the following functions can also be
set up on this machine:
● Cylinder surface transformation (TRACYL) (Page 122)
● End face machining (TRANSMIT) (Page 125)
For a single-channel or two-channel turning machine, you can configure the following channel-
specific machine data, for example:
118
a
Distance to the last cut, SD55595
Retraction between plunge-cutting and stock removal, SD55596
0.1 mm or 0.1 inch retraction depth
a
Retraction depth before turning
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
X
Z
SINUMERIK Operate