Siemens SINUMERIK 828D Commissioning Manual page 940

Introduction
Tools
● UTF8-capable editor (e.g. the integrated editor of the user interface or Notepad)
● A graphics program is needed to create graphics/display images.
File names and coding
Note
When using HMI Operate in the NCU, note that all file names are written in lower case letters
(com, png, txt) on the CF card. This is required because of Linux.
On the PCU, you can write file names either in upper case or lower case letters. However, it
is recommended that you also use lower case letters here, in case of a possible subsequent
transfer to Linux.
Note
Make sure that the coding is set to UTF-8 in the editor that you are using when saving the
configuration and language files.
Storage paths
Note the following convention when storing the configuration files, language files, etc.
[System Siemens directory]
[System oem directory]
[System user directory]
[System add_on directory]
Storage locations
10
"Run MyScreens" configuration:
Configuration file:
Language files:
Linux: /card/siemens/sinumerik/hmi
Windows 7: C:\ProgramData\Siemens\MotionControl\siemens
Linux: /card/oem/sinumerik/hmi
Windows 7: C:\ProgramData\Siemens\MotionControl\oem
Linux: /card/user/sinumerik/hmi
Windows 7: C:\ProgramData\Siemens\MotionControl\user
Linux: /card/addon/sinumerik/hmi
Windows 7: C:\ProgramData\Siemens\MotionControl\addon
[System oem directory] /proj
[System oem directory] /cfg
[System oem directory] /lng
Programming Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Integrate Run MyScreens