Manufacturer Cycles - Siemens SINUMERIK 828D Commissioning Manual

SD55483 $SCS_DRILL_TAPPING_SET_GG24[0]
= 0
= 1
= 2
Tapping (CYCLE84)
SD55484 $SCS_DRILL_TAPPING_SET_MC[0]
= 0
= 1
7.3

Manufacturer cycles

7.3.1 Manufacturer cycles
The following cycles are also available in the cycle package for individual adaptation:
CUST_TECHCYC.SPF
CUST_800.SPF
CUST_832.SPF
CUST_MEACYC.SPF
CUST_T
CUST_M6
CUST_MULTICHAN
CUST_CLAMP
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Precontrol, the same as before the cycle call (default value).
FFWON
FFWOF
For MCALL, reactivate spindle operation (default value).
For MCALL, remain in position controlled spindle operation.
Manufacturer cycle for the adaptation of technology cycles.
Manufacturer cycle for the adaptation of the swivel plane and the swivel
tool functions (CYCLE800), see Chapter "Manufacturer cycle
CUST_800.SPF (Page 159)".
Manufacturer cycle for the adaptation of the high speed settings function
(CYCLE832), see Chapter "Manufacturer cycle CUST_832.SPF
(Page 168)".
Manufacturer cycle for the adaptation of the measuring functions, see
Chapter "Manufacturer and user cycle CUST_MEACYC.SPF
(Page 173)".
Cycle is used to track the T preparation after SERUPRO.
Cycle is used to track the tool change after SERUPRO.
Manufacturer cycle for lathes with several channels
Manufacturer's cycle for clamping elements
Configuring cycles
7.3 Manufacturer cycles
Setting tapping G group 24:
Precontrol
Spindle operation for MCALL
81