End Face Machining (Transmit) - Siemens SINUMERIK 828D Commissioning Manual

MD24805 $MC_TRACYL_ROT_AX_FRAME_1
= 2
MD24810 $MC_TRACYL_ROT_SIGN_IS_PLUS_1
= 1
MD24820 $MC_TRACYL_BASE_TOOL_1[ ]
[0] = 0
[1] = 0
[2] = 0
7.5.10

End face machining (TRANSMIT)

Function
The end faces of a turned part are machined with the end face machining function
(TRANSMIT).
Setting up
For general settings for transformations, please refer to Chapter "Cylinder surface
transformation (TRACYL) (Page 122)".
You can make additional settings in the following channel-specific machine data:
MD24100 $MC_TRAFO_TYPE_1
= 256
= 257
MD24200 $MC_TRAFO_TYPE_2
= 256
= 257
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Software option
You require the following software option in order to use this function:
"Transmit and peripheral surface transformation"
Machining without Y1 axis
Machining with Y1 axis
Machining without Y1 axis
Machining with Y1 axis
Configuring cycles
Axial offset of the rotary axis is taken into
account during TRACYL.
Sign of the rotary axis for the 1st TRACYL
transformation
Vector of the base tool for the 1st TRACYL
transformation.
End face machining, main spindle: Trans‐
formation 1
End face machining, counterspindle:
Transformation 2
7.5 Turning
125