Setting-Up Shopturn Cycles For Turning - Siemens SINUMERIK 828D Commissioning Manual

Rounding the contour
SD55582 $SCS_TURN_CONT_TRACE_ANGLE
= 5
7.5.3

Setting-up ShopTurn cycles for turning

MD52210 $MCS_FUNCTION_MASK_DISP
Bit 0 = 1
Bit 1 = 1
Bit 4 = 1
MD52212 $MCS_FUNCTION_MASK_TECH
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
Bit 8
Bit 9
Bit 11
Bit 12
MD52214 $MCS_FUNCTION_MASK_MILL
Bit 3
Bit 4
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Specifies the angle between the cutting edge and contour, above which for contour turning,
the contour is rounded in order to remove residual material (default value).
Dimension system for programs always in the basic system (default setting)
Face view when turning (default setting)
Display follow-on tool in the T,F,S window
Approach logic for stepped drill
Block search cycle for ShopMill / ShopTurn
= 0 The E__ASUP or F_S_ASUP cycles are not called in the block search cycle
PROG_EVENT.SPF
= 1 The E__ASUP (under ShopMill) or F_S_ASUP (under ShopTurn) cycles are not called in
the block search cycle PROG_EVENT.SPF
Approach logic using the cycle
The cycle for SERUPRO (CYCLE207) is called in the block search cycle
PROG_EVENT.SPF.
Work offset value WO cannot be entered
Identification of the end of tool lives in the program (ShopMill / ShopTurn)
Manual machine (ShopMill/ShopTurn)
Selection/deselection of the work offset using softkey
Deactivate position check for drilling and milling tools
Alarm at positive Z offset
"Inner/rear" machining is enabled in the ShopTurn screens which themselves define the
machining plane.
If you have implemented the "Clamp/release spindle" function using the manufacturer
cycle CUST_TECHCYC.SPF, then using this machine data, you can activate the "Clamp/
release spindle" parameter in the drilling and milling screens.
= 0 The "Clamp/release spindle" parameter is not displayed in the drilling and milling screens.
ShopTurn automatically clamps the spindle if it makes sense for the particular machining
operation.
= 1 The "Clamp/release spindle" parameter is displayed in the drilling and milling screens.
You decide for which machining operation the spindle should be clamped.
Configuring cycles
7.5 Turning
Contour turning: Minimum angle for
rounding on the contour
Function mask display
Cross-technology function mask
Milling function screen
109