Magazine Location Adapter Parameter Identifiers; Multitool Parameter Identifiers - Siemens SINUMERIK 828D Commissioning Manual

9.2.2.6

Magazine location adapter parameter identifiers

The following identifiers are used in the configuration file for the magazine location adapter
parameters:
Identifier
MagPlaceAdapterLength1
MagPlaceAdapterLengthGeoAx1
MagPlaceAdapterLength2
MagPlaceAdapterLengthGeoAx3
MagPlaceAdapterLength3
MagPlaceAdapterLengthGeoAx2
MagPlaceAdapterTrafoNo
Parameter corresponds to the system variable or the system variable is the basis for this parameter.
*)
9.2.2.7

Multitool parameter identifiers

For the multitool parameters, the following identifiers are used in the configuration file:
Identifier
MultiToolNo
MultiToolNumberOfPlaces
MultiToolNumberOfPlacesRO
MultiToolIdent
MultiToolInMag
MultiToolInPlace
MultiToolInMagInPlace
MultiToolMyMag
MultiToolMyPlace
MultiToolPlaceSpec
MultiToolPlaceSpecIdent
MultiToolSizeLeft
MultiToolSizeRight
MultiToolSizeUpper
MultiToolSizeDown
MultiToolOverSize
MultiToolPosition
MultiToolProtAreaFile
MultiToolKindOfDist
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Parameter or property
Magazine location adapter length 1
Magazine location adapter geometry axis 1 $TC_ADPT1
Magazine location adapter length 2
Magazine location adapter geometry axis 3 $TC_ADPT2
Magazine location adapter length 3
Magazine location adapter geometry axis 2 $TC_ADPT3
Magazine location adapter transformation
number
Parameter or property
Number of the multitool
Number of multitool locations
Number of multitool locations, only read ac‐
cess
Name of the multitool
Magazine in which the multitool is located
Magazine location containing the multitool
Magazine number/Magazine location
Owner magazine of the multitool
Owner magazine location of the multitool
Location type
Location type as text
Multitool size to the left in half locations
Multitool size to the right in half locations
Multitool size to the top in half locations
Multitool size to the bottom in half locations $TC_MTP6
Multitool size as fixed setting - two half lo‐
cations left, two half locations right, one half
location top, one half location bottom
Multitool position
File name of the multitool description which
is required to determine the protection zone
Type of distance input of the multitool loca‐
tions
Tool management
9.2 Configuring the user interface
System variable
$TC_ADPT1
$TC_ADPT2
$TC_ADPT3
$TC_ADPT4
System variable
-
$TC_MTPN
$TC_MTPN
$TC_MTP2
$A_TOOLMN
$A_TOOLMLN
$A_TOOLMN /
$A_TOOLMLN
$A_MYMN
$A_MYMLN
$TC_MTP7
$TC_MTP7
$TC_MTP3
$TC_MTP4
$TC_MTP5
$TC_MTP3 -
$TC_MTP6
$TC_MTP_POS
$TC_MTP_PROTA
$TC_MTP_KD
*)
*)
247