Configure The Code Carrier Connection - Siemens SINUMERIK 828D Commissioning Manual

Tool management
9.2 Configuring the user interface
</TOOLCHANGEREASON>
See also
For configuring new parameters, see Configuring list parameters (Page 249).
9.2.24

Configure the code carrier connection

Requirement
<IDENTCONNECTIONCONFIGURATION> tag
The entries used for configuring the code carrier connection in the tool list of the user interface
are located in the <IDENTCONNECTIONCONFIGURATION> tag. The code carrier
connection is implemented via TDI Ident Connection.
284
<REASON4>
<Text value="TM_DGL_PREMATURE_WEAR" type="QString" />
<BitMask value="8" type="int" />
</REASON4>
<REASON5>
<Text value="TM_DGL_TYPE_REEQUIPPING" type="QString" />
<BitMask value="16" type="int" />
</REASON5>
<REASON6>
<Text value="TM_DGL_TOOL_TRIAL" type="QString" />
<BitMask value="32" type="int" />
</REASON6>
<REASON7>
<Text value="TM_DGL_PREVENTIVE_CHANGE" type="QString" />
<BitMask value="64" type="int" />
</REASON7>
Software option
You require the "Access MyTool ID" option for this function (Tool Ident Connec‐
tion).
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate