Measuring Tools At The Milling Machines - Siemens SINUMERIK 828D Commissioning Manual

Configuring cycles
7.9 Measuring cycles and measurement functions
SD54606 $SNS_MEA_WP_TRIG_PLUS_DIR_AX3[n]
SD54607 $SNS_MEA_WP_POS_DEV_AX1[n]
SD54608 $SNS_MEA_WP_POS_DEV_AX2[n]
SD54609 $SNS_MEA_WP_STATUS_RT
SD54610 $SNS_MEA_WP_STATUS_GEN[n]
SD54611 $SNS_MEA_WP_FEED[n]
7.9.4.3

Measuring tools at the milling machines

Settings
SD54762 $SNS_MEA_FUNCTION_MASK_TOOL
Bit 3
Bit 4
Bit 5
Bit 7
Bit 8
Bit 9
Bit 10
Bit 11
Bit 12
Bit 13
Input, measurement feedrate is valid for AUTOMATIC and JOG
1)
Calibration data of the tool probe, referred to the machine coordinate system
Before calibration is started, the position of the tool probe in the machine coordinate system
(MCS) must be entered into the following general cycle setting data. In this case, the reference
point is the outer diameter or the tool length of the active tool in the spindle. If there is no tool
in the spindle, the reference points are the spindle center point and the tool reference point at
the spindle.
192
Setting for the input screen, measuring cycles in the automatic mode, tool measurement,
enable tool probe calibration data field to be selected
Select calibration input measuring feed (VMS)
Select input feedrate and spindle speeds when probing
Select measurement in MCS and WCS
Select measurement, absolute and incremental
Select tool offset, geometry and wear
Select individual cutting edge measurement
Selects spindle reversal when calibrating in the plane
Select number of measurements (_NMSP)
Select experience values (_EVNUM)
Trigger point, plus direction,
3rd measuring axis opposite to the tool
direction. In the default case = 0.
Position deviation,
1st measuring axis in the plane.
Position deviation,
2nd measuring axis in the plane.
Calibration status of the axis positions
Calibration status
Measuring feedrate when calibrating
Setting for the input screen, measuring
cycles in the automatic mode, tool meas‐
urement
1)
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate