Editor For The Tool And Magazine Management; Overview - Siemens SINUMERIK 828D Commissioning Manual

The programming in the NC program is called:
T4 MTL=1
Example
The following table shows the task status and the preparation of the acknowledgment with the
position specification for the change.
Data block
DB4300.DBB0
DB4300.DBB1
DB4300.DBW6
DB4300.DBW8
DB4300.DBW10
DB4300.DBW12
DB4300.DBW56
DB4300.DBW58
DB4300.DBD60
DB4300.DBW64
DB4300.DBW66
DB4300.DBW68
DB4300.DBW70
DB4200.DBB0
DB4200.DBW4
In a replacement cycle for T, $C_MTL_PROG can read whether MTL was programmed. The
programmed value for MTL can be read with $C_MTL .
The acknowledgment is made with the total acknowledgment.
DB4200.DBW4: For the acknowledgment, the actual position of the multitool on the NC can
be notified in this data item. If the position does not match the position requested in the NC
task, an alarm is triggered. If the position is not notified to the NC (DB4200.DBW4 = 0), no
check of the correct multitool position is made. Value "0" is permitted only for the total
acknowledgment.
9.8

Editor for the tool and magazine management

9.8.1

Overview

The tool management offers the possibility to define all real tool magazines and internal
magazines with the appropriate properties from the operating software and link them channel-
specific with the tool unit. You can configure the relationships between tool magazine, griper
and spindle via a tree view.
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
9.8 Editor for the tool and magazine management
Meaning
Task
Task description
Source magazine number
Source location number
Target magazine number
Target location number
Multitool type
Multitool location count
Multitool distance
Source multitool number
Source multitool location number
Target multitool number
Target multitool location number
Acknowledgment
Multitool location number
Tool management
Value
10000001
00010110
1
4
9998
1
1
2
1.0000
2
1
0
0
00000001
0
311