Multitool Location Parameter Identifiers - Siemens SINUMERIK 828D Commissioning Manual

Tool management
9.2 Configuring the user interface
Identifier
MultiToolKindOfDistRO
MultiToolDistAngle
MultiToolState
MultiToolStateEnabled
MultiToolStateLocked
MultiToolStateLockedRO
MultiToolStateInChange
MultiToolStateFixed
MultiToolStateUsed
MultiToolStateAutoReturn
MultiToolStateIgnoreLocked
MultiToolStateMarkedToUnload
MultiToolStateMarkedToLoad
MultiToolStatePermanent
MultiToolState1To1Exchange
MultiToolStateHandTool
MultiToolStateLockMtIfToolLock
MultiToolUser_1, ... MultiToolUs‐
er_10
MultiToolAppl_1, ... MultiToo‐
lAppl_10
Parameter corresponds to the system variable or the system variable is the basis for this
*)
parameter.
9.2.2.8

Multitool location parameter identifiers

For the multitool location parameters, the following identifiers are used in the configuration file:
Identifier
MultiToolDist
MultiToolDistLength
MultiToolDistAngle
MultiToolPlaceType
MultiToolPlaceTypeIdent
MultiToolPlaceState
MultiToolPlaceStateLocked
248
Parameter or property
Type of distance input of the multitool loca‐
tions, only read access
Type of distance input of the multitool loca‐
tions as an angle
Multitool status in the hexadecimal notation $TC_MTP8
Multitool status - multitool released
Multitool status - multitool locked
Multitool status - multitool locked, only read
access
Multitool status - multitool is being changed $TC_MTP8, Bit5
Multitool status - multitool fixed location co‐
ded
Multitool status - multitool was in use
Multitool status - automatic return
Multitool status - do not observe locked sta‐
tus
Multitool status - multitool is selected to be
unloaded
Multitool status - multitool is selected to be
loaded
Multitool status - multitool is a master tool
Multitool status - one to one replacement
Multitool status - manual tool
Multitool status - multitool is locked if a tool
is locked in multitool
OEM multitool parameters 1 to 10
Siemens application multitool parameters
1 to 10
Parameter or property
Multitool location distance taking into account
the actual type of distance input of the multitool
Multitool location distance, length
Multitool location distance angle, angle
Location type
Location type as text
Multitool status in the hexadecimal notation
Multitool location locked
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
System variable
*)
$TC_MTP_KD
$TC_MTP_KD
$TC_MTP8, Bit1
$TC_MTP8, Bit2
$TC_MTP8, Bit2
$TC_MTP8, Bit6
$TC_MTP8, Bit7
$TC_MTP8, Bit8
$TC_MTP8, Bit9
$TC_MTP8, Bit10
$TC_MTP8, Bit11
$TC_MTP8, Bit12
$TC_MTP8, Bit14
$TC_MTP8, Bit15
$TC_MTP8, Bit16
$TC_MTPC1, ...
$TC_MTPC10
$TC_MTPCS1, ...
$TC_MTPCS10
System variable
*)
-
$TC_MTPPL
$TC_MTPPA
$TC_MTPP2
$TC_MTPP2
$TC_MTPP4
$TC_MTPP4, Bit0
SINUMERIK Operate