Siemens SINUMERIK 828D Commissioning Manual page 678

Tool management
9.7 Deploy multitool
location distance). The PLC program must appropriately initiate the machine so that the active
tool in the multitool can do the machining.
An alarm is output if the name of a multitool is programmed.
Example
The following table shows the task status and the preparation of the acknowledgment without
the position specification for the change.
Data block
DB4300.DBB0
DB4300.DBB1
DB4300.DBW6
DB4300.DBW8
DB4300.DBW10
DB4300.DBW12
DB4300.DBW56
DB4300.DBW58
DB4300.DBD60
DB4300.DBW64
DB4300.DBW66
DB4300.DBW68
DB4300.DBW70
DB4200.DBB0
DB4200.DBW4
In addition to the "normal" task data, the following are set:
Data block
DB4100.DBX0.7
DB4100.DBW56
DB4300.DBW58
DB4300.DBD60
DB4300.DBW64
DB4300.DBW66
DB4300:DBW68
DB4300:DBW70
The acknowledgment is made with the total acknowledgment.
Tool call with T=<magazine location number>
For the programming of the multitool location number in the magazine, you must program the
multitool location number with "MTL = p" (p = location number). The programmed value for
MTL must correspond to an existing location number in the selected multitool. If not, an alarm
is triggered.
310
Meaning
Task
Task description
Source magazine number
Source location number
Target magazine number
Target location number
Multitool type
Multitool location count
Multitool distance
Source multitool number
Source multitool location number
Target multitool number
Target multitool location number
Acknowledgment
Multitool location number
Meaning
Data is present in the extended area. The tool is a multitool.
Type of the distance coding (= 1, = location)
Multitool location count
Multitool distance, the angle for angular coding
Multitool number of the new tool
Multitool location number of the new tool
Data of the old tool, if present
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Value
10000001
00010110
1
4
9998
1
1
2
2.0000
2
2
0
0
00000001
0
SINUMERIK Operate