Siemens SINUMERIK 828D Commissioning Manual page 410

Configuring the network
4.4 Station-related network diagnostics
● Address type
Information about the configuration of the network adapter in the configuration file
"basesys.ini":
– DHCP: DHCP is active for this network adapter.
– Manual
● IP address assigned
The current IP address of the network adapter.
● Subnet mask assigned
The subnet mask of the network adapter.
● DHCP server
The IP address of the DHCP server (for address type "DHCP").
● State, DHCP server
State of the synchronous DHCP server:
– Active: The current NCU is active in the group of NCUs in the "Synced Server" mode and
transfers the IP addresses.
– Standby: The NCU is not active as DHCP server. If the active DHCP server fails, this NCU
can take over the task of theDHCP servers.
● Mode, DHCP synchronous
Priority of the synchronous DHCP server:
Low, high, master
● DNS server 1, DNS server 2
The IP address of the DNS server.
● Gateway
The IP address of the host that is to be assigned as gateway.
Note
All information that is not available is marked in the relevant table line with a hyphen "-".
42
The information behind the hyphen "-" specifies the DHCP mode of operation:
Off - DHCP is deactivated for this adapter
Client - a DHCP client that receives an IP address and further data from a server, is
running on the interface
Server - the SINUMERIK control provides a DHCP server at this interface that supplies
clients on this network with IPs
If no changes have been made for the network adapters in the configuration file, then
"Default" is also output.
The "Change" softkey allows manual settings, see "Changeable parameters" and
"Address types" sections.
Note
In the "Change" mode, either "Manual" or "DHCP" can be selected (only for company
network, X130).
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate