Setting Up The Counterspindle Under Shopturn - Siemens SINUMERIK 828D Commissioning Manual

Note
MD52207[n] bit 4 = *)
Bit 4 can be set from the operator's view (values as specified) or according to DIN ("0" and "1"
are then interchanged).
The display must be the same for the main spindle and the counterspindle ("from operator's
view" or "according to DIN").
Dimensions
To define the reference point for moving the counterspindle, you must first announce the
dimensions of the counterspindle. You can either enter the dimensions in the following axis-
specific cycle machine data or in menu "Parameter" → "Setting data" → "Spindle chuck data."
Changes to the machine data are automatically accepted in the menu and vice versa.
MD53240 $MAS_SPINDLE_PARAMETER[ ]
[0]
[1]
[2]
MD52241 $MCS_SPINDLE_CHUCK_TYPE
= 0
= 1
7.5.5

Setting up the counterspindle under ShopTurn

The position to which the counterspindle travels when the program starts is defined in the
following channel-specific cycle setting data:
SD55232 $SCS_SUB_SPINDLE_REL_POS
The following channel-specific setting data become effective when traveling to the fixed stop:
SD55550 $SCS_TURN_FIXED_STOP_DIST
SD55551 $SCS_TURN_FIXED_STOP_FEED
SD55552 $SCS_TURN_FIXED_STOP_FORCE
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Chuck dimensions
Stop dimensions
Jaw dimensions
Clamping, outer
Clamping, inner
Software option
You require the following software option in order to use the counterspindle on your
machine:
"Generic coupling 'CP-STATIC'" or higher
Spindle chuck data
Spindle jaw type
Retraction position Z for counterspindle
Distance for travel to fixed stop.
Feedrate for travel to fixed stop.
Force for travel to fixed stop in %.
Configuring cycles
7.5 Turning
113