Siemens SINUMERIK 828D Commissioning Manual page 602

Tool management
9.2 Configuring the user interface
Entries
CombinedToolMonitoring
FiltersCombinedWithOr
MagazineMoveMessage
ToolLoadErrorMessage
The following settings refer to markings in the lists:
True - marking is displayed.
False - marking is not displayed (default setting).
If several markings apply to one location, the most important information is displayed. For
instance, if a tool is locked, and at the same time, the "Tool position" and the "Reference
234
Meaning
Specifies the combined monitoring types offered in the tog‐
gle field:
● Time/Count - tool life and workpiece count
● Time/Wear - tool life and wear monitoring
● Count/Wear - workpiece count and wear monitoring
● Time/WearDlSc - tool life and wear monitoring for
additive and setup offsets
● Count/WearDlSc - workpiece count and wear monitoring
for additive and setup offsets
● Time/Count/Wear - tool life, workpiece count and wear
monitoring
● Time/Count/WearDlSc - tool life, workpiece count and
wear monitoring for additive and setup offsets
Defines the filter criteria, which are linked in the filter window
using a logical OR. The default setting for all the filter criteria
is a logical AND. The possible entries are:
● "StandBy" - for tools that are ready for use
● "Active" - for tools with active identifier
● "Locked" - for locked tools
● "Prewarn" - for the prewarning limit
● "RemainingPieces" - for the remaining unit quantity
● "RemainingTime" - for the remaining tool time
● "MarkedToUnload" - for the unload identifier
● "MarkedToLoad" - for the load identifier
True - "Magazine movement running" or "Magazine move‐
ment ended" message is displayed.
False - default setting, message is not displayed.
Refers to the output of the fault message due to a negative
PLC.
True - default setting, the fault message is displayed.
False - the fault message is not displayed.
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate