Siemens SINUMERIK 828D Commissioning Manual page 643

Assignment between the magazine or magazine locations and the coordinate system
With this setting, magazines and magazine locations can be assigned to coordinate systems.
This is useful if the machine is configured in such a way that a magazine or magazine location
does not match the position of the coordinate system set in the channel. The assignment
between magazine or magazine location and coordinate system can be defined here.
As a consequence of this configuration, the tool icons are output with reference to their position
depending on the coordinate system.
This setting option is only available in turning technology and in milling technology with the
technology extension milling.
<COORDSYSMAGAZINEASSIGNMENT> tag
In tag <COORDSYSMAGAZINEASSIGNMENT>, you will find the entries for the assignment
between magazines or magazine locations and coordinate systems.
Entries
COORDSYSNO_XXX
Magazines
MAGAZINE_XXX
Places
Example
The following assignment between magazines or magazine locations and coordinate systems
is to apply:
Magazine 1,3, and 4
Magazine 2
Magazine 9998 location 2
<COORDSYSMAGAZINEASSIGNMENT>
<COORDSYSNO_34>
</COORDSYSNO_34>
<COORDSYSNO_33>
</COORDSYSNO_33>
</COORDSYSMAGAZINEASSIGNMENT>
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Meaning
XXX stands for the number of the coordinate system.
Number of the magazines that are assigned to the channel.
Number of the magazine whose locations will be assigned to the coordinate
system.
Number of magazine locations that will be assigned to the coordinate system.
<Magazines value="1 3 4" type="QString" />
<Magazines value="2" type="QString" />
<MAGAZINE_9998>
<Places value="2" type="QString" />
</MAGAZINE_9998>
Coordinate system 34
Coordinate system 33
Coordinate system 33
Tool management
9.2 Configuring the user interface
275