Siemens SINUMERIK 828D Commissioning Manual page 491

MD24400 $MC_TRAFO_TYPE_4
= 512
= 513
= 514
Note
You must also set up other machine data for each of the individual transformations.
Setting up cylinder surface transformation under ShopTurn
In addition, set the following channel-specific configuration machine data:
MD52214 $MC_FUNCTION_MASK_MILL
Bit 3 Enable "inside/rear" machining in ShopTurn screens which define the machining plane themselves.
Bit 4 If you have implemented the "Clamp/release spindle" function by means of the machine manufacturer cycle
CUST_TECHCYC.SPF, you can activate the "Clamp/release spindle" parameter in the drilling and milling
screens with this machine data.
= 0 The "Clamp/release spindle" parameter is not displayed in the drilling and milling masks.
ShopTurn automatically clamps the spindle if it makes sense for the particular machining operation.
=1 The "Clamp/release spindle" parameter is displayed in the drilling and milling masks.
The operator decides for which machining operation the spindle should be clamped.
Cylinder surface transformation without groove side offset
MD24300 $MC_TRAFO_TYPE_3
= 512
MD24310 $MC_TRAFO_AXES_IN_3[ ]
[0] = 1
[1] = 3
[2] = 2
MD24320 $MC_TRAFO_GEOAX_ASSIGN_TAB_3[ ]
[0] = 1
[1] = 3
[2] = 2
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
without groove wall correction (without Y1 axis)
with groove wall correction (with Y1 axis)
with groove wall correction and Y1 correction
TRACYL main spindle.
Perpendicular to the rotary axis X1
Rotary axis (main spindle) C1
Parallel to the rotary axis Z1
1st channel axis X1
2nd channel axis Y1
3rd channel axis Z1
Cylinder surface transformation, counter‐
spindle: Transformation 4
Milling function screen
Definition of 3rd transformation in channel
Axis assignment for transformation 3
Assignment of the geometry axes to chan‐
nel axes for transformation 3.
Configuring cycles
7.5 Turning
123