Configuring cycles
7.5 Turning
[6] = C2
[7] = X2
[8] = Z2
MD20080 $MC_AXCONF_CHANAX_NAME_TAB[ ]
[0] = X2
[1] = Z2
[2] = SP2
[3] = Z3
[4] = SP1
[5] = C1
[6] = C2
7.5.8
Example: Two-channel turning machine with general axis configuration
Example of a general axis configuration on the following turning machine:
Axis configuration
For the two-channel machine shown, you must configure the following machine data:
MD10000 $MN_AXCONF_MACHAX_NAME_TAB[ ]
[0] = MX1
[1] = MY1
[2] = MZ1
[3] = MC1
[4] = MSP1
[5] = MZ3
[6] = MC2
120
Counterspindle C2
Channel axis X2
Channel axis Z2
Channel axis X2
Channel axis Z2
Tool spindle SP2
Counterspindle axis Z3 (default passive)
Tool spindle SP1
Main spindle C1 (default passive)
Counterspindle C2 (default passive)
X1 axis in the first channel
-
X1 axis in the first channel
Main spindle C1
Tool spindle SP1
Linear axis toward counter spindle active in channel 1 and 2
Counterspindle C2
Channel axis name in channel 2
Machine axis name
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate