Renault Laguna III Manual page 3133

Vehicle on repair bench: Description
I - MAIN REFERENCE POINTS BEFORE TRIM-
SETTING
1 - Front mechanical components in place
The jig covers the rear bolt of the front subframe (A) .
Use this situation for a rear impact or a light frontal im-
pact without removal of the mechanical components.
2 - Front mechanical components removed
The jig rests under the subframe mounting unit and is
centred in the threaded hole (A) .
GENERAL INFORMATION
124329
124902
Two possible cases can arise:
- if the rear of the vehicle is being rebuilt, these two
points alone may be used to align and support the
front of the vehicle.
- for a light frontal impact not requiring removal of the
front axle sub-frame.
Note:
If it is suspected that one of these points may be
deformed, use two additional points located in an
area not affected by the impact in order to confirm
trim-setting.
II - SECONDARY FRONT TRIM-SETTING
REFERENCE POINT
The jig rests under the front side member, centre sec-
tion and is centred on the hole (M) .
Use this situation for a major front impact requiring re-
placement of the front subframe rear mounting unit.
40A-3
40A
124902