Juniper ACX1000 Configuration Manual page 625

Release History Table
Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
(Optional) Include the
2.
is not configured for a given interface.
The device uses the configured link protection LFA as the backup for the primary link.
[edit protocols isis backup-spf-options]
user@host# set node-link-degradation
Enable automatically targeted LDP sessions using the loopback addresses between
3.
the PLR and the remote LFA node.
[edit protocols ldp]
user@host# set auto-targeted-session
Specify a time interval for which the targeted LDP sessions are kept up even after the
4.
remote LFA node goes down.
[edit protocols ldp auto-targeted-session]
user@host# set teardown-delay seconds
For example, to set a teardown delay value of 60 seconds:
[edit protocols ldp auto-targeted-session]
user@host# set teardown-delay 60
Specify the maximum number of automatically targeted LDP sessions to optimize
5.
memory usage.
[edit protocols ldp auto-targeted-session]
user@host# set maximum-sessions number of sessions
For example, to set a maximum sessions allowed to 20:
[edit protocols ldp auto-targeted-session]
user@host# set maximum-sessions 20
Release Description
14.2 Starting in Junos OS Release 14.2, the primary goal of a remote loop-free
alternate (LFA) is to increase backup coverage for IS-IS routes and provide
protection especially for Layer 1 metro-rings.
auto-targeted-session
remote-backup-calculation
no-eligible-remote-backup
Example: Configuring Remote LFA over LDP Tunnels in IS-IS Networks
Understanding Remote LFA over LDP Tunnels in IS-IS Networks on page 564
statement even if node-link protection
node-link-degradation
Chapter 18: Configuring Routing Protocols
567