Juniper ACX1000 Configuration Manual page 660

ACX Series Universal Access Router Configuration Guide
602
Create a Gigabit Ethernet interface and enable MPLS on that interface. Create the
3.
loopback ( lo0 ) interface:
[edit interfaces]
user@host# set ge-0/2/0 unit 0 family inet address 20.1.1.2/24
user@host# set ge-0/2/0 unit 0 family mpls
user@host# set lo0 unit 0 family inet address 70.1.1.1/32
Enable the MPLS and RSVP protocols on the MPLS interface—
4.
[edit]
user@host# edit protocols
[edit protocols]
user@host# set rsvp interface ge-0/2/0.0
user@host# set mpls interface ge-0/2/0.0
Configure LDP. If you configure RSVP for a pseudowire, you must also configure
5.
LDP:
[edit protocols]
user@host# set ldp interface ge-0/2/0.0
user@host# set ldp interface lo0.0
Configure a point-to-point label-switched path (LSP) and disable constrained-path
6.
LSP computation:
[edit protocols]
user@host# set mpls label-switched-path PE1-to-PE2 to 40.1.1.1
user@host# set mpls no-cspf
Configure OSPF and enable traffic engineering on the MPLS interface—
7.
and on the loopback (
[edit protocols]
user@host# set ospf traffic-engineering
user@host# set ospf area 0.0.0.0 interface ge-0/2/0.0
user@host# set ospf area 0.0.0.0 interface lo0.0 passive
Uniquely identify a Layer 2 circuit for the TDM pseudowire:
8.
[edit protocols]
user@host# set l2circuit neighbor 40.1.1.1 interface t1-0/0/0.0 virtual-circuit-id 1
Results
[edit]
user@host# show
chassis {
fpc 0 {
pic 0 {
framing t1;
}
) interface:
lo0
ge-0/2/0.0 :
ge-0/2/0.0
Copyright © 2017, Juniper Networks, Inc.
,