Juniper ACX1000 Configuration Manual page 693

Copyright © 2017, Juniper Networks, Inc.
[edit protocols rsvp]
user@A1# set interface ge-1/3/0.0
user@A1# set interface ge-1/3/1.0
user@A1# set interface lo0.0
Configure LDP on the core-facing interfaces and on the loopback interface.
3.
LDP is used in Layer 2 domain.
[edit protocols ldp]
user@A1# set interface ge-1/3/0.0
user@A1# set interface ge-1/3/1.0
user@A1# set interface lo0.0
Configure MPLS on the core-facing interfaces.
4.
[edit protocols mpls]
user@A1# set interface ge-1/3/0.0
user@A1# set interface ge-1/3/1.0
Configure an interior gateway protocol, such as IS-IS or OSPF, on the core-facing
5.
interfaces and on the loopback interface.
[edit protocols isis]
user@A1# set interface ge-1/3/0.0
user@A1# set interface ge-1/3/1.0
user@A1# set interface lo0.0
On the interface that faces the customer edge, configure the Layer 2 circuit.
6.
Configure the
hot-standby
virtual circuits (VCs) (Device A1 in our topology). You must include the
pseudowire-status-tlv
the standby flag cannot be advertised to remote provider edge (PE) devices.
The statement and the
revert-time
access routers. Without the
transitioned to the primary path upon completion of the restoration. If a
delay is defined but a
upon the revert timer's expiration. The maximum option allows the VCs to be
restored in a scattered fashion rather than all at once.
[edit protocols l2circuit neighbor 192.168.0.101 interface ge-1/3/2.600]
user@A1# set virtual-circuit-id 1
user@A1# set pseudowire-status-tlv
user@A1# set revert-time 10 maximum 60
user@A1# set backup-neighbor
user@A1# set backup-neighbor 192.168.0.102 hot-standby
To have the unilist next hop get pushed to other access routers, configure per-packet
7.
load balancing.
[edit policy-options policy-statement pplb]
user@A1# set then load-balance per-packet
Chapter 20: Configuring MPLS and Pseudowires
statement on those routers with both active and standby
statement on access routers. Without the status TLV signaling,
option must also be configured on
maximum
revert-time statement, traffic of all the VCs will not be
delay is not, then VCs are restored immediately
maximum
192.168.0.102 virtual-circuit-id 2
revert-time
635