Packet Flow On Acx Series Routers; Figure 3: Acx2200 Interface Port Mapping; Figure 4: Acx Series Router Packet Forwarding And Data Flow - Juniper ACX2200 Hardware Manual

ACX2200 Universal Access Router Hardware Guide
Related
Documentation

Packet Flow on ACX Series Routers

6

Figure 3: ACX2200 Interface Port Mapping

ACX2200
MGMT CONSOLE/AUX
ALARM
1PPS 10MHz
IN OUT IN OUT
0 1
SYS EXT REF CLK IN
ACX2200 Universal Access Router Overview on page 3
The class-of-service (CoS) architecture for ACX Series routers is in concept similar to
that of MX Series routers. The general architecture for ACX Series routers is shown in
Figure 4 on page 6.

Figure 4: ACX Series Router Packet Forwarding and Data Flow

Ingress classification
In order of
decreasing precedence:
Incoming packet
MF classification (DFW)
Fixed classification
BA classification
Based on the model, ACX routers contain a built-in Routing Engine and Packet Forwarding
Engine and can contain both T1/E1 and Gigabit Ethernet Ports.
The Packet Forwarding Engine has one or two "pseudo" Flexible PIC Concentrators.
Because there is no switching fabric, the single Packet Forwarding Engine takes care of
both ingress and egress packet forwarding.
Fixed classification places all packets in the same forwarding class, or the usual multifield
(MF) or behavior aggregate (BA) classifications can be used to treat packets differently.
BA classification with firewall filters can be used for classification based on IP precedence,
DSCP, IEEE, or other bits in the frame or packet header.
However, the ACX Series routers can also employ multiple BA classifiers on the same
physical interface. The physical interfaces do not have to employ the same type of BA
classifier. For example, a single physical interface can use classifiers based on IP
precedence as well as IEEE 802.1p. If the CoS bits of interest are on the inner VLAN tag
of a dual-tagged VLAN interface, the classifier can examine either the inner or outer bits.
(By default, the classification is done based on the outer VLAN tag.)
Eight queues per egress port support scheduling using the weighted deficit round- robin
(WDRR) mechanism, a form of round-robin queue servicing. The supported priority levels
are strict-high and default (low). The ACX series router architecture supports both
weighted random early detect (WRED) and weighted tail drop (WTD).
All CoS features are supported at line rate.
FPC 0, PIC 0
GE 0/0/0-0/0/3
GE
0/0/2 0/0/3 0/1/2 0/1/3
0/0/0 0/0/1 0/1/0 0/1/1
COMBO PORTS
FPC 0, PIC 1
GE 0/1/0-0/1/3
Buffering Queuing Scheduling
Copyright © 2017, Juniper Networks, Inc.
FPC 0, PIC 2
GE 0/2/0-0/2/1
0/1/2 0/1/3 0/2/1
0/1/0 0/1/1 GE 0/2/0 0/3/0 XE 0/3/1
FPC 0, PIC 3
XE 0/3/0-0/3/1
Outgoing packet
Egress rewrite