Ipv6 Access Control Lists (Ipv6 Acls); Ipv6 Acl Commands; Cam-Acl - Dell Force10 S4810P Reference Manual

Ftos command line reference guide for the s4810 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 S4810P:

Table of Contents

IPv6 Access Control Lists (IPv6 ACLs)

IPv6 ACLs and IPv6 Route Map commands are supported on Dell Force10 E-Series, C-Series, S-Series S4810. or Z9000

This chapter contains the following sections

IPv6 Route Map Commands

NOTE: For IPv4 ACL commands, refer to the

Important Points to Remember

E-Series platforms require IPv6-ExtACL content addressable memory (CAM) profile to support IPv6 ACLs.

C-Series and S-Series platforms require manual CAM usage space allotment. For more information, refer to the

Egress IPv6 ACL and IPv6 ACL on the Loopback interface is not supported.

Reference to an empty ACL permits any traffic.

ACLs are not applied to self-originated traffic (for example, Control Protocol traffic not affected by IPv6 ACL

because the routed bit is not set for Control Protocol traffic and for egress ACLs the routed bit must be set).

You can use the same access list name for both IPv4 and IPv6 ACLs.

You can apply both IPv4 and IPv6 ACLs on an interface at the same time.

You can apply IPv6 ACLs on physical interfaces and a logical interfaces (Port-channel/VLAN).

Non-contiguous masks are not supported in source or destination addresses in IPv6 ACL entries.

Because the prefix mask is specified in /x format in IPv6 ACLs, inverse mask is not supported.

IPv6 ACL Commands

The following commands configure IPv6 ACLs.

Allocate space for IPv6 ACLs.

C-Series, E-Series, S-Series, S4810

cam-acl {default | l2acl 1-10 ipv4acl 1-10 ipv6acl 0-10 ipv4qos

1-10 l2qos 1-10}

Access Control Lists (ACL)