Timers Bgp - Dell N1100-ON Reference Manual

See the associated neighbor commands for a description of parameters and
keywords. Note that Dell EMC Networking does not support a remote-as as-
number command in this mode. The neighbor's AS number must be
specified when the neighbor is created.
Command History
Introduced in version 6.2.0.1 firmware. Additional command options added
in 6.3.0.1 firmware.
Example
console(config)# router bgp 65000
console(config-router)# neighbor 172.20.1.2 remote-as 65001
console(config-router)# neighbor 172.20.2.2 remote-as 65001
console(config-router)# template peer AGGR
console(config-rtr-tmplt)# timers 3 9
console(config-rtr-tmplt)# address-family ipv4
console(config-rtr-tmplt-af)# send-community
console(config-rtr-tmplt-af)# route-map RM4-IN in
console(config-rtr-tmplt-af)# route-map RM4-OUT out
console(config-rtr-tmplt-af)# exit
console(config-rtr-tmplt)# address-family ipv6
console(config-rtr-tmplt-af)# send-community
console(config-rtr-tmplt-af)# route-map RM6-IN in
console(config-rtr-tmplt-af)# route-map RM6-OUT out
console(config-rtr-tmplt-af)# exit
console(config-rtr-tmplt)# exit
console(config-router)# neighbor 172.20.1.2 inherit peer AGGR
console(config-router)# neighbor 172.20.2.2 inherit peer AGGR
console(config-router)# address-family ipv6
console(config-router)# neighbor 172.20.1.2 activate
console(config-router)# neighbor 172.20.2.2 activate

timers bgp

The timers bgp command configures the default keepalive and hold timers
that BGP uses for all neighbors unless specifically overridden by the neighbor
timers command.
Syntax
timers bgp keepalive holdtime
no timers bgp
1382
Layer 3 Routing Commands