Changing Bgp Timers; Enabling Bgp Neighbor Soft-Reconfiguration - Dell S6000–ON Configuration Manual

Dampening enabled. 0 history paths, 0 dampened paths, 0 penalized paths
Neighbor AS
10.114.8.34 18508 82883
10.114.8.33 18508 117265
Dell>
To view which routes are dampened (non-active), use the show ip bgp dampened-routes command
in EXEC Privilege mode.

Changing BGP Timers

To configure BGP timers, use either or both of the following commands.
Timer values configured with the neighbor timers command override the timer values configured
with the timers bgp command.
When two neighbors, configured with different keepalive and holdtime values, negotiate for new
values, the resulting values are as follows:
• the lower of the holdtime values is the new holdtime value, and
• whichever is the lower value; one-third of the new holdtime value, or the configured keepalive
value is the new keepalive value.
• Configure timer values for a BGP neighbor or peer group.
CONFIG-ROUTER-BGP mode
neighbors {ip-address | peer-group-name} timers keepalive holdtime
– keepalive: the range is from 1 to 65535. Time interval, in seconds, between keepalive messages
sent to the neighbor routers. The default is 60 seconds.
– holdtime: the range is from 3 to 65536. Time interval, in seconds, between the last keepalive
message and declaring the router dead. The default is 180 seconds.
• Configure timer values for all neighbors.
CONFIG-ROUTER-BGP mode
timers bgp keepalive holdtime
– keepalive: the range is from 1 to 65535. Time interval, in seconds, between keepalive messages
sent to the neighbor routers. The default is 60 seconds.
– holdtime: the range is from 3 to 65536. Time interval, in seconds, between the last keepalive
message and declaring the router dead. The default is 180 seconds.
To view non-default values, use the show config command in CONFIGURATION ROUTER BGP mode
or the show running-config bgp command in EXEC Privilege mode.

Enabling BGP Neighbor Soft-Reconfiguration

BGP soft-reconfiguration allows for faster and easier route changing.
Changing routing policies typically requires a reset of BGP sessions (the TCP connection) for the policies
to take effect. Such resets cause undue interruption to traffic due to hard reset of the BGP cache and the
time it takes to re-establish the session. BGP soft reconfig allows for policies to be applied to a session
without clearing the BGP Session. Soft-reconfig can be done on a per-neighbor basis and can either be
inbound or outbound.
BGP soft-reconfiguration clears the policies without resetting the TCP connection.
208
MsgRcvd MsgSent TblVer
79977 780266
25069 780266
InQ OutQ Up/Down State/PfxRcd
0 2 00:38:51 118904
0 20 00:38:50 102759
Border Gateway Protocol IPv4 (BGPv4)