Clear Control-Traffic Queue - Dell Z9500 Command Reference Manual

Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.8.0
Usage
There are three line cards (0-2) with fixed ports on the Z9500. Line card 0 uses
Information
three sets of ports (port pipes): 0 to 2; line cards 1 and 2 use four sets of ports: 0 to
3.
•
•
To display the per-protocol counters of rate-limited control-plane traffic at the
aggregated (switch) or line card and port set level, use the show control-
traffic protocol command.
Example
Dell#clear control-traffic protocol cp-switch counters
Dell#

clear control-traffic queue

Clear per-queue counters of rate-limited control-plane traffic.
Z9500
Syntax
clear contol—traffic queue {all | queue-number} counters
Parameters
all
queue-number
590
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
On line card 0, port set 0 consists of ports 0–44; port set 1 consists of ports
48–92; port set 2 consists of ports 96–140.
On line cards 1 and 2, port set 0 consists of ports 0–44; port set 1 consists of
ports 48–92; port set 2 consists of ports 96–140; port set 3 consists of ports
144–188.
Enter the keyword all to clear counters for rate-limited
traffic on all CPU queues, including Route Processor, Control
Processor, and line-card CPUs.
Enter the queue number to clear counters for rate-limited
traffic on a specified CPU queue. The range of queue-
number values is from 0 to 23. The twenty-four control–
plane queues are divided into groups of eight queues for the
Route Processor, Control Processor, and line-card CPUs as
follows:
• Queues 0 to 7 process packets destined to the Control
Processor CPU .
Control Plane Policing (CoPP)