Udf-Id - Dell Z9500 Command Reference Manual

udf-id

Assign value for each configured UDF ID in the given UDF TCAM profile.
Syntax
udf-id id value mask
To return to the default settings, use the no udf-id 1-12 value mask
command.
Parameters
id
value
mask
Defaults None
Command CONFIGURATION-UDF-Qualifier-Value Profile
Modes
Example
Dell(conf-udf-tcam-qual-val)#udf-id 1 aa ff
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.8(0.0)
Related
udf-qualifier-value
Commands
udf-tcam
show config
udf-qualifier-value
Create a UDF qualifier value to assign values for all UDF IDs.
Syntax
udf-qualifier-value name
To return to the default settings, use the no udf-qualifier-value name
command.
Parameters
name
342
Enter the UDF ID range. The range is from 1 to 12.
Enter the value for the UDF in Hex, up to 24 bytes.
Enter the mask for the UDF in Hex, up to 24 bytes.
Description
Introduced on the S6000, Z9500.
— creates a UDF qualifier value.
— creates a context for UDF TCAM.
— displays the current UDF -Qualifier-Value Profile configuration.
Enter the UDF qualifier value profile name, up to 64
characters.
Access Control Lists (ACL)