Dell Z9500 Command Reference Manual page 230

Parameters
prefix-list-
name
StartingSeqNu
m
Step-to-
Increment
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.11.1
8.1.1.0
7.8.1.0
7.6.1.0
7.5.1.0
7.4.1.0
Usage
When you have exhausted all the sequence numbers, this feature permits re-
Information
assigning a new sequence number to entries of an existing prefix list.
Related resequence access-list
Commands
seq
Assign a sequence number to a deny or permit filter in an IP access list while creating the filter.
Z9500
Syntax
seq sequence-number {deny | permit} {source [mask] | any | host
ip-address}} [count [bytes]] [dscp value] [order] [fragments]
[log [interval minutes] [threshold-in-msgs [count]] [monitor]
To delete a filter, use the no seq sequence-number command.
230
Enter the name of the configured prefix list, up to 140
characters long.
Enter the starting sequence number to resequence. The
range is from 0 to 65535.
Enter the step to increment the sequence number. The
range is from 1 to 65535.
EXEC
EXEC Privilege
Description
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the E-Series ExaScale
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— resequences an access-list.
Access Control Lists (ACL)