Write - Dell Z9500 Command Reference Manual

Version
9.2(1.0)
9.0.0.0
8.3.19.0
8.3.12.0
8.1.1.0
7.5.1.0
E-Series
Usage You can configure both IPv4 and IPv6 virtual addresses simultaneously, but only
Information one of each. Each time this command is issued, it replaces the previously
configured address of the same family, IPv4 or IPv6. The no virtual-ip
command takes an address/prefix-length argument, so that the desired address
only is removed. If you enter the no virtual-ip command without any specified
address, then both IPv4 and IPv6 virtual addresses are removed.
Related ip address
Commands

write

Copy the current configuration to either the startup-configuration file or the terminal.
Z9500
Syntax
write {memory | terminal}
Parameters
memory
terminal
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
190
Description
Introduced on the Z9500.
Introduced on the Z9000
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Original command.
— assigns a primary and secondary IP address to the interface.
Enter the keyword memory to copy the current running
configuration to the startup configuration file. This
command is similar to the copy running-config
startup-config command.
Enter the keyword terminal to copy the current running
configuration to the terminal. This command is similar to the
show running-config command.
Control and Monitoring