Dell Z9500 Command Reference Manual page 761

Defaults As indicated above.
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.1(0.0)
8.3.19.0
8.3.12.0
Related
ip ssh server
Commands
show ip ssh
client-pub-
keys
Usage
Both inbound and outbound SSH sessions using IPv4 or IPv6 addressing are
Information
supported. Inbound SSH supports accessing the system through the management
interface as well as through a physical Layer 3 interface.
Example
If FIPS mode is not enabled:
Dell#ssh 10.11.8.12 ?
-c
-l
-m
-p
-v
<cr>
Dell#ssh 10.11.8.12 -c ?
3des-cbc
Dell #ssh 10.11.8.12 -m ?
hmac-sha1
hmac-sha1-96
hmac-md5
hmac-md5-96
With FIPS mode enabled:
Dell#ssh 10.11.8.12 ?
-c
-l
-m
-p
FIPS Cryptography
Description
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Configure an SSH server.
Display the client-public keys.
NOTE: Some of the parameters in this command require licensing to access.
For more information, contact your Dell Networking representative.
Encryption cipher to use (for v2 client
User name option
HMAC algorithm to use (for v2 clients only)
SSH server port option (default 22)
SSH protocol version
Force ssh to use 3des-cbc encryption cipher
Force ssh to use hmac-sha1 HMAC algorithm
Force ssh to use hmac-sha1-96 HMAC algorithm
Force ssh to use hmac-md5 HMAC algorithm
Force ssh to use hmac-md5-96 HMAC algorithm
Encryption cipher to use (for v2 client
User name option
HMAC algorithm to use (for v2 clients only)
SSH server port option (default 22)
761