Permit Ip - Dell Z9500 Command Reference Manual

Command CONFIGURATION-UDF TCAM
Modes
Example
Dell(conf-udf-tcam)#match l2ethertype ipv4 ipprotocol 4
vlantag any
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.8(0.0)
Related
udf-tcam
Commands
show config

permit ip

Associate the UDF in IP access-list.
Syntax
permit ip {source mask | any | host ip-address} {destination
mask | any | host ip-address} udf-pkt-format name udf-
qualifier-value name
To remove this filter, use the no seq sequence-number command.
Parameters
source
mask
any
host ip-address
destination
udf-pkt-format
name
udf-qualifier-
value name
340
Description
Introduced on the S6000, Z9500.
— creates a context for UDF TCAM.
— displays the current UDF TCAM profile configuration.
Enter the IP address of the network or host from which the
packets were sent.
Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or noncontiguous.
Enter the keyword any to specify that all routes are subject
to the filter.
Enter the keyword host then the IP address to specify a host
IP address.
Enter the IP address of the network or host to which the
packets are sent.
Enter the keywords udf-pkt-format then the UDF ACL
profile name.
Enter the keywords udf-qualifier-value then the UDF
qualifier value profile name.
Access Control Lists (ACL)