Debug Ftpserver - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

This command enables (and disables) the collection of CPU traffic statistics from

the time this command is executed (not from system boot). However, excessive

traffic a CPU receives automatically triggers (turn on) the collection of CPU traffic

The following message is an indication that collection of CPU traffic is

automatically turned on. To view the traffic statistics, use the show cpu-

traffic-stats command.

If the CPU receives excessive traffic, traffic is rate controlled.

show cpu-traffic-stats

debug ftpserver

View transactions during an FTP session when a user is logged into the FTP server.

debug ftpserver

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Control and Monitoring

NOTE: This command must be enabled before the show cpu-traffic-

stats command displays traffic statistics. Dell Networking recommends

disabling debugging (no debug cpu-traffic-stats) after troubleshooting

is complete.

— displays the cpu traffic statistics.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the Z9000.

Introduced on the E-Series ExaScale.

Introduced on the S-Series.

Introduced on the C-Series.