Dell Z9500 Command Reference Manual page 848

Version
6.1.1.0
Usage When creating an interface range, interfaces appear in the order they are entered;
Information they are not sorted. The command verifies that interfaces are present (physical) or
configured (logical).
Important Points to Remember:
•
•
•
•
•
Example (Bulk)
Dell(conf)#interface range te 10/0, fo 0/0, te 2/0
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example
Dell(conf)#interface range te 2/0 - 23, te 2/1 - 10
(Multiple Ports)
Dell(conf-if-range-te-2/0-23#
Example
Dell(conf)#interface range te 2/1 - 11, te 2/1 - 23
(Overlapping
Dell(conf-if-range-te-2/1-23#
Ports)
Usage
Only VLAN and port-channel interfaces created using the interface vlan and
Information
interface port-channel commands can be used in the interface range
command.
Use the show running-config command to display the VLAN and port-channel
interfaces. VLAN or port-channel interfaces that are not displayed in the show
running-config command cannot be used with the bulk configuration feature of
the interface range command. You cannot create virtual interfaces (VLAN,
Port-channel) using the interface range command.
Example (Single
This example shows a single range bulk configuration.
Range)
Dell(config)# interface range tengigabitethernet 1/1 - 23
Dell(config-if-range)# no shutdown
Dell(config-if-range)#
848
Description
Introduced on the E-Series.
Bulk configuration is created if at least one interface is valid.
Non-existing interfaces are excluded from the bulk configuration with a
warning message.
The interface range prompt includes interface types with slot/port
information for valid interfaces. The prompt allows for a maximum of 32
characters. If the bulk configuration exceeds 32 characters, it is represented by
an ellipsis ( ... ).
When the interface range prompt has multiple port ranges, the smaller port
range is excluded from the prompt.
If overlapping port ranges are specified, the port range is extended to the
smallest start port and the biggest end port.
NOTE: If a range has VLAN, physical, and port-channel interfaces, only
commands related to physical interfaces can be bulk configured. To configure
commands specific to VLAN or port-channel, only those respective interfaces
should be configured in a particular range.
Interfaces